Preliminary Investigation Of A Blast Load Generator

Preliminary Investigation of a Blast Load Generator

The Blast Load Generator is under development at the U.S. Army Engineers Waterways Experimental Station at Vicksburg, Mississippi. It will be used to simulate blast loading for experimental effects studies. Propellant burning inside cylindrical perforated tubes is used to pressurize the Blast Load Generator. Picatinny Arsenal analog personnel were requested to simulate the operation, in order to arrive at the correct propellant charge for generation of given required pressures. Results obtained with a preliminary analog simulation setup gave an approximate picture of the Blast Load Generator. It was established that the over-pressure can be controlled by the vent area, the amount of propellant, and the propellant web. However, since the analog setup is still in its initial stages, several important items must be determined before accurate design of the charges can be undertaken. For example, the thermal coefficients and the effective surface area for heat transfer must be determined. Hence, the results presented in this report can be seen only as approximations and should be used only to indicate trends and guide future tests. (Author).

Technical Abstract Bulletin

List of Publications of the U.S. Army Engineers Waterway Experiment Station